New member Username: Mikehooch
Post Number: 1
Registered: Mar-07
|
Posted on I need to know if i can bridge my subwoofer (specs below) into a 2 channel amp (specs below)
Amp (Power Acoustik LT1440/2):
Number of Channels: 2
RMS Power (4 ohms): 300 watts x 2 chan.
RMS Power (2 ohms): 360 watts x 2 chan.
RMS Power (1 ohm): Not Stable
Bridged RMS Power: 720 watts x 1 chan.
Peak Power Output: 1440 watts
Min. Impedance Unbridged: 2 ohms
Min. Impedance Bridged: 4 ohms
THD @ Rated RMS Power: <0.02%
Speaker Level Inputs: Yes
Amp Preamp Outputs: Yes - 1 Pair
Built-in Crossover: Yes
High-Pass Crossover: 50 Hz - 500 Hz
Low-Pass Crossover: 30 Hz - 500 Hz
Subsonic Filter: N/A
Signal-to-Noise Ratio: >98 dB
Channel Separation: >55 dB
Bass Boost: 0 - 24 dB
Bass/Gain Remote: N/A
Fan Cooled: N/A
Fuse Rating: 20A x 4
Subwoofer (Solo Baric Kicker L7)
Size:12 inch
Impedance:2 ohms DVC
Max Rec Amplifier Power (Watts Peak/RMS):1500/750 |