perfecto, that will work... I see your learning ground symbols and stuff... just make sure u get a solid couple strands of 0ga to ground... in front and in the back.
well my intention wasn't that in the biggining. i already have a 0 gague going from the alt to the batt so i figured i split that so one will go to the back.
now that i think about it, would that split the current. so instead of full current going from alt to the front batt i would only get half current. damn this is so confusing.
id make a run fromthe alt to the fisrt bat and another run from the alt to the back then a run connecting each battery and you definatly should run a 1/0 ground from each battery too
marc that is how my batteries are connected right now. i want to do 2 runs so i was just gonna disconnect the - and put it on +. then i would just ground both batteries to the chasis.
I'm just going to do 0awg big 3, 1 run of 0awg power back to the kinetik monster and 1 run of 4awg back to my 100.4 and ground them both out in the back of my car where the seats are bolted down.
I see your learning ground symbols and stuff... just make sure u get a solid couple strands of 0ga to ground... in front and in the back. 
I thought you knew what you were doing!