|
Silver Member Username: QcsfinestCharlotte, North Carolina Post Number: 205 Registered: Jun-05 | how do you wire two 500/1 to a 15sx. and how hard would it be |
|
Silver Member Username: JkidderSpring hill, Florida Usa Post Number: 187 Registered: Nov-05 | one to each voice coil.. jus wire in parallel i believe |
|
Gold Member Username: TjmutlowPost Number: 2358 Registered: Sep-05 | if that is a dual voice coil, then use one per voice coil, and make sure gains are as close to same on each amp |
|
Gold Member Username: B101Queen City, NC USA Post Number: 3215 Registered: Sep-05 | measure the output from the speaker terminals, make sure they are the same output from both amplifiers.. play a 60hz test tone, and measure the AC voltages on each! Hook each amp up to each vc... thats it! |
|
Gold Member Username: TheelfkeeperStockbridge, GA USA Post Number: 2390 Registered: Feb-05 | i ran 2 500/1's on my 13W7 a while back. just make sure all adjustments are the same for both amps. check out the Gain setting/Input Sensitivity Tutorial on www.JLAudio.com for more info. also B, JL says to use a 50Hz tone. not sure how playing a 60 would change things, but JL's Voltages are based off a 50Hz tone being played. |
|
Gold Member Username: B101Queen City, NC USA Post Number: 3223 Registered: Sep-05 | any voltage can be used as a refrence voltage... but if JL says 50hz, then use that... |
|
Silver Member Username: QcsfinestCharlotte, North Carolina Post Number: 206 Registered: Jun-05 | ok thanks, i was about to trade my 1000/1 for two 500/1's and some money back because i have two cars so i want to be able to switch amps around and be able to have one in each car if i want. |
|
Bronze Member Username: CbrownPost Number: 39 Registered: Jun-06 | yeah trade it two jl 500/1s would be louder |