when i installed my W7 into my box ( like 7-8 months ago) I can't remember if i hooked up the + to the black terminal cup and the - to the red terminal, my question is if i hooked this up for a few minutes would this be very bad for the sub? i am powering with about 475-500 watts.
it will sound bad, but not damage the sub.... it just makes the sub play out of phase... if ur amp has a phase shift button, u can use that with the subs wired the way u describe, then it will play normall..
yea , but it's a job and a half just to take the W7 out because of it's mounting procedures.( the o ring, and the silver clip that goes over the o ring.)
just take a some wire and put them to ur sub outs, put the wire on a 9v sqaure battery, the sub will rise or sink, u want it to rise, so what ever u put the pos and neg. to on the bettery will be the same as u put it on the amp
yup, it's hooked up properly, the sub excured a tiny bit, kinda made a raspy sound too. But i only tapped the battery a few times , i didn't hold it there for more then 3 seconds.
