Very Easy Question...PLEASE Answer


New member
Username: Azngotskills

Sugar Land, TX USA

Post Number: 8
Registered: Jan-06
I was to make sure I understand this clearly... I want to power my components with the 2 front channels (4ohms) and bridge the rear for a subwoofer (2ohms). The reason Im asking is b/c i dont know what voice coil configuration to go with and if the front and rear channels can run different ohm loads?

Bronze Member
Username: C10_250

Kailua, Hawaii

Post Number: 22
Registered: Dec-05
Are you using one four channel amplifier in this configuration. Most four channel amplifiers aren't 2 ohm stable when bridged. You may want to check on that and decide from there.

Bronze Member
Username: ___

Pittsburgh, PA U.S.A.

Post Number: 49
Registered: Mar-06
Mark Gemina
what component speakers?
what amp?
what sub, is it dvc?

Bronze Member
Username: Azngotskills

Sugar Land, TX USA

Post Number: 11
Registered: Jan-06
Arc XXK 4150
IDQ 4ohm DVC
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us