i was testin out how my 10w1 would do with the proper wattage its rated at 125 rms but the jl site says it can handle 240 rms which isnt recomended and past that it will void the waranty blah blah blah i hooked it up to my friends amp that pushes 200 rms @4 ohms not even the volume half way up the sub started making a poping noise this happens if you push a sub to hard correct ? well i doubt the sub was even gettin 100 rms anyone know why that would happen ? i doubt clipping either cause my friend hooked his subs back in and cranked it up and it pounded just fine