Regulatig and wiring amp


New member
Username: Nando11

Post Number: 1
Registered: Nov-05
i have 2 10" memphis 15-mc104 svc 400 watt subwoofers
and a boss 850 watt mono amp what is the best way to wire them and how should i regulate the amp. when i turn up the volume i really don't like the way the woofer think i might need a bigger amp.
max power 2ohm:850x1
rms power,4ohm:200wx1
rms power,4ohm:n/a
bridge power,4oh:n/a
rms/peak 200/400
4ohm voice coil

Silver Member
Username: Theelfkeeper

Stockbridge, GA USA

Post Number: 589
Registered: Feb-05
boss amps aren't really that great. your not getting that 850 watts at 2 ohms.(wire the subs in parallel for a 2 ohm load) another amp would sound better. you prob just need to adjust the gains if you say it doesn't sound right when you turn it up. try to turn the amp gain all the way down and turh the HU up to about 3/4 up, then adjust the amp gain until it starts to sound distorted, then turn it down a little bit.

New member
Username: Nando11

Post Number: 5
Registered: Nov-05
what do you mean by gains sorry not too familiar with this.i currently have them bridged on the amp the only nobs that is has are loss pass wich go from 45-90 and input level nob sys min-max. i'm just looking for a deeper bass.i just don't know if a biggeror better amp would really make that much of a difrence
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us