|
New member Username: Melody25Chesapeake, OH USA Post Number: 6 Registered: Oct-05 | I have a PowerAcoustik Hyper Bass series LT1920/2 amp pushing 2 Audiobahn SE 12" subs at 4ohms. They are set up to push 370 rms per sub. Should I leave the factory settings on the amp or how can I adjust them to get deep/clean bass. I listen to a lot of rap and hip hop. Any advice would be appreciated. |
|
Silver Member Username: TdisantoPost Number: 350 Registered: Sep-05 | Well, I hope you set your gain already. If you didnt then go here www.bcae1.com and learn how to set it properly. If your amp has a LPF (Low Pass Filter) on it than turn that on, if its adjustable set it at like ~80Hz. This basically will roll off freq. above whatever its set too and only allow freq below that point to be amplified and sent to the subs. |
|
New member Username: Melody25Chesapeake, OH USA Post Number: 7 Registered: Oct-05 | Thanx, so far it's been installed but all the settings are factory. I haven't adjusted or set anything. When my stereo is on, I can hear music but there is absolutly no bass hitting. I'm not sure why though. |
|
Gold Member Username: RovinTrinidad & T... Post Number: 1223 Registered: Jul-05 | Could be the way the subs box was built or tuned ..... |
|
New member Username: Melody25Chesapeake, OH USA Post Number: 8 Registered: Oct-05 | What settings on the amp would maximize the bass? |
|
Silver Member Username: QuickshotCharlotte, North Carolina U.S. Post Number: 316 Registered: Aug-05 | well if your amp has the "factory settings"(or whatever in he11 that means) you have to turn up the gain knob until you can hear audible distortion then you turn it down slightly |