Power [Max]: 1200W Nominal Power: 600W 2" Aluminum Dual Voice Coil Silver Chrome Basket Sensitivity: 88dB Dual 4 Ohm Frequency: 27Hz - 3KHz Mounting Depth: 150 mm Mounting Diameter: 370 mm Free Air Resonance: 25.6 Hz Efficiency (1W/1M) 87.3 dB Total Speaker "Q": 0.88 Electrical "Q": 1.30 Mechanical "Q": 4.35 VAS: 332.5L
And a 1 Volfenhag Amplifier, either a ZX-7190:
2400 Watts Max Power @2 Ohms 800 Watts RMS Power @2 Ohms 560 Watts RMS Power @4 Ohms 800 Watts x 1 Channel @4 Ohms Bridged 2ohm stable Dual Power Meters Tri-mode capable Fan cooling system Soft Delayd Remote Turn On Channel seperation:>60dB Signal to noise ratio:97dB Frequency response:20Hz-20KHz HPF:50Hz-1KHz LPF:30Hz-250Hz Adjustable sensitivity range:0.1V-1V Input impedance:Low level(10K ohms), High level(100 ohms) Dimension(WxHxL)mm:282x59x479
Or a Volfenhag ZX-7180:
1600 Watts Max Power @2 Ohms 640 Watts RMS Power @2 Ohms 440 Watts RMS Power @4 Ohms 640 Watts x 1 Channel @4 Ohms Bridged 2ohm stable Dual Power Meters Tri-mode capable Fan cooling system Soft Delayd Remote Turn On Variable bass boost:0-18dB Variable bass frequency:30Hz-100Hz Channel seperation:>60dB Signal to noise ratio:97dB THD 0.03% Frequency response:20Hz-20KHz HPF:50Hz-1KHz LPF:30Hz-250Hz Adjustable sensitivity range:0.1V-1V Input impedance:Low level(10K ohms), High level(100 ohms) Dimension(WxHxL)mm:262x59x429
Would somebody please let me know which amp i should get? And also i understand that if i wire them in series/parallel i will be running 2.6 something Ohms and both amps can handle that. But i dont know how to wire them, should i just bridge the amp into one channel and then run the subs in series/parallel and if i do that, which amp will i be able to run to get the most power out of the subs but not too much? Or should i wire them differently or perhaps just buy a single channel amp?
neither one. you need a mono (one channel) amplifier that's 2 ohm stable, for three of those subs. you'll need to wire the coils in series to get three 8 ohm subs, then wire all 3 subs in parallel to get a 2.6666 ohm load. only way to run that configuration. can't do it with a bridged two channel amp that's only stable to 4 ohms bridged.