I just installed some new spakers, and everything works fine and sounds fine, except for when I like flick my lights on or use my turn signal. For a brief half a second, the speakers will cut out. I know ill probably end up going and prolly redoing all my wiring to find it but Just curious if anyone has any experience with this issue. So knows more than likely what it is. I was thinking a bad ground, but if it was a bad ground wouldn't my amps protect light come on?
My setup goes like this Kenwood deck to 4channel amp, to my speakers. Also im using a Hi-to-Low converter for my speakers, if that helps.
Oh, im using the high to low converter because my deck has 1 preout and its already used by my subwoofer and mono amp.
So it goes Kenwood RCA out to Mono Amp to sub(but my sub doesnt cut out, however it does kinda make a pop noise whenever i start my car other than that it works fine)
Then Kenwood to factory speaker wires to high low converter to my 4 channel amp, 4 channel amp to speakers with 14 g speaker wire.