I have a Memphis PR200.2 Amplifier on my speakers. AMP is not bridged! I am using this amp with some of my factory speakers which I believe are 10ohms a piece! Two ACDELCO 6*9 @ 10ohms, Two ACDELCO 6&1/2 @ 10ohms, and Two BOSE 4*6 @ 2/4ohms (not sure) which I installed as extra in my dash. The amps kicks these speakers hard, I do notice that the bose in the dash are louder. Must be getting extra power. Problem is that the AMPlifier overheats and goes into protect mode after about 1hour of use @ high levels. Is this due to my speaker configuration? I am open to any sugestions. I do plan on replacing the factory speakers with 4ohms when I get the $$. Please help. AMP is brand NEW!
My goal is to push 6 speakers! with the Memphis PR200.2 Amplifier. My speaker slots are as above 4*6, 6*9, 6.5. If I place all 4ohm speakers in these slots will my AMP stop overheating and going into protect? Thinkin about SONY speakers.
AMP SPECS: RMS power 2ohm: 140*2 RMS power 4ohm: 100*2