Bronze Member
Username: Shanmag Post Number: 21 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 12:24 GMT is there any difference in sound between a 2ohm sub and a 4ohm sub? if the amp can take both, which is more recommended?
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1983 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 13:33 GMT 2 ohms will give you more power from you're amp. An amp might put out 400 watts rms at 4 ohms, but wired at 2 ohms, it will put out 800 watts rms. Ohms doesn't really effect the way the sub sounds.
Bronze Member
Username: Shanmag Post Number: 25 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 13:38 GMT ok cos im planning on getting a jl slash 1000.1 and it says it can take 2ohm or 4ohm. so if i get 2 500W subs (either alpine type r or kicker cvr), would it be better of getting a 2ohm or 4ohm?
Silver Member
Username: Tdeaton1021 Near Tampa,
Florida
USA
Post Number: 557 Registered: Sep-04
Posted on
Tuesday, June 07, 2005 - 13:53 GMT is they are single voice coil then you can get either.... just make sure both are the same. if you had two 2 ohm subs you would wire them into 4ohms... if you had two 4ohm subs you would wire them into 2 ohms....
Bronze Member
Username: Shanmag Post Number: 26 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 13:56 GMT im leaning more towards the alpine's, they r dual voice coil! does this make a difference?
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1987 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 13:57 GMT Jl amps put out 1000 watts rms at 11V to 14V, and from 1.5 ohms to 4 ohms. It doesn't really matter what ohms they are. I'd go with the 2 ohm though... no real reason.
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1988 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 13:59 GMT I like the Alpines better as well, they are the 05 mottles, not the 04 mottles right?
Bronze Member
Username: Shanmag Post Number: 27 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 14:05 GMT well im from australia, so they r the new ones that r out here, model number SWR-1242D
Bronze Member
Username: Shanmag Post Number: 28 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 14:09 GMT and im guessing mottles = models? otherwise, im so confused
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1991 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 14:11 GMT If they can handle 500 watts rms... then there the new ones. I like them a lot... that should sound sweet!
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1992 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 14:12 GMT lol sorry about my spelling... what are you so confused about?
Bronze Member
Username: Shanmag Post Number: 29 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 14:13 GMT yeh they r the new ones then! thanx for all ur help
Bronze Member
Username: Shanmag Post Number: 30 Registered: Jun-05
Posted on
Tuesday, June 07, 2005 - 14:13 GMT haha no its ok, i just wasnt too sure wot mottles meant but i guessed it was models!
Gold Member
Username: Taylor17 Kopperl,
Texas
Post Number: 1993 Registered: Jan-05
Posted on
Tuesday, June 07, 2005 - 14:16 GMT lol half of the time I don't really think... and the other half of the time I just can't spell.:-)