2 2ohm dvc cvr15s wiring options

 

Retz
Unregistered guest
Hello. My amp has the following RMS specs:
300x2 @ 2ohm
200x2 @ 4ohm
600x1 @ 4ohm bridged

Each sub can individually be wired into 1 or 4 ohms. I was wondering if I could wire one into a 1 ohm, the other into a 4ohm and them bridge them in series for a total of 5 ohms. That would get me near the 600 watts.
 

New member
Username: Bmocbarker

KY

Post Number: 5
Registered: May-05
The 4+1 setup you describe would work well if you were wiring a midrange with a sub, but with two subs...not so good! It isn't the output POWER of an amp that makes strong bass...it's output CURRENT (CURRENT=acceleration!)! If you wire each with a different resistance, a different share of the CURRENT will go to each sub and a lot of your bass will get cancelled out! You'll get much better output and sound quality by going 200x2 into 4ohm each sub!
 

Retz
Unregistered guest
Alright, thx
 

Silver Member
Username: Addicted2bass

Miami, FLORIDA USA

Post Number: 700
Registered: Nov-04
your only option with that amp is to wire ieach sub in series on their own channel.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us