i have recently been having a problem with my sub. when i have it playing pretty loud and it comes to a pretty bassy part, my sub just stops. I called circuit city(where i got my amp installed at) and had them take a look at it and he said that my wire terminal is bad. he could be right about it, but i think it is fine. i was just wondering what you guys think is wrong with it. i dont think its over heating and going into a safe mode, but i could be wrong.
make sure you have a good solid grounding poing for you amp and make suree that its hasnt heated up and oxidised or anything like that. i like to use the seat belt bolts or something similar.
i recently had a problem like this. make sure your using the same guage wire for +ive and -ive.
and make sure all you crimp or screw terminals are tight
also crank it up and watch the amp to make sure it isnt going into safe mode or turning off or anthing
check where your wires connect and looked for a small led that says "prot" or protect or anything that resembles that then crank it up like u would normally and see if that light comes on when it shuts off. if so u might have to low of an ohm load for your amp or your amp is about done