hey i was wondering if someone can help me plz i want to wire 2 audio bahn subs >>>AW1251SE 12" NATURAL SOUND WOOFER 45 oz. Strontium Magnet Power Handling: 400 watts R.M.S. Frequency Response: 24Hz - 1kHz Efficiency: 92.1 dB PHAT Foam Surround Non- Pressed, Non-Transfer Paper Cone KM3' Coated for Virtually No Cone Distortion 2" 4-Layer ASV Voice Coil Dual 4 Ohm 2 Ohm or 8 Ohm Operation Mounting Dimensions: Depth; 5 1/4" Hole; 10 7/8" Diameter; 12 1/2" Mult-Connect Lug Lock Terminals http://www.audiobahn.com/frame2004.html
the stats for my amp are: SPECIFICATIONS:
Total system power 4 ohm: 1200 watts. RMS WATTS PER CHANNEL 4 ohm:80x4. RMS WATTS PER CHANNEL 2 ohm: 240x4. RMS WATTS bridget 4 ohm: 600x2. single to noise ratio: 90dB. Total Harmonic Distortion: 0.1% Treble / Bass controls - 10Hz - 50 KHz, 50dB POWER REQUIREMENTS(neg ground): 11-16DC. Maximum Crrent draw: 60amps. Dimensions(WXHXD)mm: 240 x 58 x 500
for my car and i have a 4 ohm 1200 watt amp( not very good brand funkysound or something) how would i got about wiring these up so i can get the most out of them and so i dont do any harm to myslef or especailly the speakers or amp lol? thanks for any help given
If I read this right... wire both in paralel to get a 2 ohm load on each sub. With both sub's wired in paralel, you will have a total ohm load of 4 ohm's. That amp bridged, puts out 600 rms at 4 ohm's. Each sub should get 300 watt's.