I recently bought 2 ALUM10Q(10" 800RMS) and 1 ALUM12Q(12"1000RMS) they are all three dual 6 Ohm vc's I was wanting to wire them at 1 Ohm but i dont know how to wire them, the amp i have is also audiobahn it pushes 1200 RMS at 1 ohm X 1 mono Im having a custom box built for my car and i want to make sure i can wire them at 1 ohm also does anyone know if this is going to sound good the subs are rated at 18hz.
Just a thought, but its usually not a good idea SQ-wise to run different size, model, or impedance subs together at the same frequency. It may "muddy" up your bass a bit. It'll be loud as heck regardless. I'm sure Jonathan or someone could comment further.
lol, I didn't wanna be the one to say that, but now that the cat's out of the bag I guess sound quality really isn't such a big issue. I'm not sure I'd spend a whole helluva lot on that custom enclosure however unless its a two/three piece jobby where you can remove that 12 if necessary. Otherwise I guess an unused 12 inch enclosure would make a nice planter. You could be the first one on your block to have a kickorz ficus tree growin in the back of your ride.
No, don't mind me. It'll probably just sound fine.