Newbie question about Zapco amp


New member
Username: Maz66

Post Number: 1
Registered: Feb-05
Hi all, Im fairly new to car audio so please bare with me. I have a Pioneer DEH-P4690MP headunit (1 set of pre-out) and i am looking at buying a set of Infinity Perfects 6.1 and a nice amp that I have my eyes set on to drive these is the Zapco Reference 350.2 (Rated at 100wrms).

However for the time being I don't need a sub (low buget :-() Although in the future I might decide to purchase one. So my question is: if I get a sub + mono block amp later on how will I hook this up to the setup since my HU doesn't have sub-out?

Bronze Member
Username: An_eagalach

Annandale, VA US

Post Number: 63
Registered: Aug-04
Nice selection of speakers and amp.

A simple solution to your problem would be to get an equalizer. An Audio Control EQ-line driver would be a good choice. That will have a sub out, plus two sets of pre-outs. The added benefit would be the ability to tweak the frequencies according to whatever sounds good to you.

New member
Username: Newbifier

Wilmington, NC USA

Post Number: 1
Registered: Feb-05
Just check to see if that amp has preamp outputs if it does you could use that output to feed a signal to the other amp.
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us