Ok guys I just want to make sure this will work without any problems. I have a digi distro block with 2 AGU fuses in it. One is for my mono amp and one is for my 4 channel amp. I want to wire it as the diagram I have attached shows:
- power wire to distro block input - positive cap terminal to distro block input - through 60 amp fuse to 4 ga output to sub amp - through 40 amp fuse to 4 ga output to 4 channel amp
The cap needs pos and neg ran to it are you gonna use another distrabution block for that? i personaly think it would be easier to just buy a power distrabution top to fit the cap but thats just me also i dont think it will feed out power as effecintly as it should because of the fact its not inline to the amp but that is also just me
Well as far as the negative terminal on the cap is concerned, I am going to ground it on the chassis. My main concern is the capacitor's power going through the fuse. Will that be of any concern?
Can anyone see a problem with my cap going through the fuses and then to my amps? Sorry for being such a pain in the a$$ but I don't want to damage anything!
