Amp cuts off when bridged


New member
Username: Jdojao

Post Number: 1
Registered: Jan-05
I have 12 1200 watt solobaric with 400 2 channel autotek amp. I also have mtx amp that is running my front and rear speakers. I'm using 4 gauge wire. Every time I bridge the autotek amp. it cuts out when the bass hits. it runs fine when it not bridged. is it the amp or the way it is installed.

Bronze Member
Username: Themax96se


Post Number: 42
Registered: Jan-05
What load are the speakers? Are you trying to run it bridge at 2ohms or less?

Gold Member
Username: Glasswolf

NorthWest, Michigan USA

Post Number: 7331
Registered: Dec-03
if the sub is dual 4 ohm coils, your amp is seeing a 1 ohm load and going into thermal protection mode.
you picked the wrong sub/amp combination.
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us