Power question for speakers


New member
Username: General

Post Number: 1
Registered: Nov-04
I have a bowick MA 150.2 rated @ 300 watts @ 4 ohms driving diamond audio M3 compents in the front... and CM3 coaxals in the back...

I resently bought a set of diamond audio 600a Hex series..

will i be able to run these news ones, and the old m3's... or will i hae to take out everything and just leave hex in the car ?

if anyone can help me, it would be appeciated

Silver Member
Username: Solacedagony

New Jersey US

Post Number: 101
Registered: Oct-04
Are you talking about running both sets of components from the same amp? Assuming you bridged your amp into two ohms and wired your sets in parallel to get the 2 ohm load, it would be possible. But should you? I'd say you would want a dedicated amp for each set of components you'd be running. Also, I don't know much about components, so I don't know how much running two sets would affect your sound.
(Sorry if I didn't answer the question, I wasn't quite sure what you were getting at.)

New member
Username: General

Post Number: 2
Registered: Nov-04
well, that was kinda answering my question.. but really im looking for is my amp powerfull enough to run the hex 600a series
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us