Bridging an amp


Unregistered guest
I have a 1600 watt peak amplifier with 4 channels
2 channels indicated as front speakers and 2 channels as rear. how would i bridge the four of them together to make 2 channels at 4ohms

Silver Member
Username: Carguy

Post Number: 246
Registered: Nov-04
Hey Robert, normally in 4 channel amp, channels 1 and 2 gets bridged to 3 and 4. You should check your manual. It should also be labeled on the speaker terminals or at the bottom of the amp case.

Gold Member
Username: Glasswolf

NorthWest, Michigan USA

Post Number: 5838
Registered: Dec-03
yeah please check the amp manual
usually there is a switch or button to enable bridged mode. then you use a specified pair of wires from the bridged channels to run the speakers.
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us