Like

Wiring subs to box.

 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 210
Registered: Dec-04
Okay, so i have two 2+2 ohm subs. Im going to wire them so they present one ohm each, equaling two. Do i wire them so that they are each one ohm and then run them to my amp? My amp has two outputs for speakers, but its a mono class d amp. Mtx thunder 801d. would this do what i need it to do.. which is present a 2 ohm load for my amp?
 

New member
Username: Who_cares_1

Post Number: 2
Registered: Sep-05
wire the voice coils in parallel and then the subs in series. that should give you an impedance of 2 ohm
 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 211
Registered: Dec-04
you mean the voice coils in series and then the subs in parallel
 

New member
Username: Who_cares_1

Post Number: 4
Registered: Sep-05
wait... r the subs dual 4 ohm, or 2 ohm?
 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 212
Registered: Dec-04
i have two terminals on my box.. i want to use them both, and present a 2 ohm load to my amp. how would i go about doing this?
 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 214
Registered: Dec-04
dual 2
 

New member
Username: Who_cares

Post Number: 1
Registered: Sep-05
ok then ya.. ur right, oops. wire the voice coils in series and then the subs in parallel
 

New member
Username: Who_cares_1

Post Number: 5
Registered: Sep-05
ok then ya... ur right, oops. wire the coils in series and then the subs themselves in parallel
 

New member
Username: Who_cares_1

Post Number: 6
Registered: Sep-05
lol, stupid account
 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 215
Registered: Dec-04
right but should i wire the subs in series and then to the box and put it on one output, and do the same for the other one on the other out put?
 

Silver Member
Username: Rovin

Trinidad & T...

Post Number: 903
Registered: Jul-05
CHECK THIS http://www.the12volt.com/caraudio/woofer_configurations.asp
 

Silver Member
Username: Sony224422

Deep River, CT US

Post Number: 216
Registered: Dec-04
haha i know how to wire them to get the ohm load i need, i just don't know if the way i want to connect it to my amp if it will get the right load. I know that im going to wire them to one ohm each, and then run each of them to the two outputs on the amp. I think it will give me the right load, since it will be 2 ohms on the one channel, since class d amps are only one channel.. even if they have more than one output spot.
« Previous Thread | Next Thread »

Facebook

Shop Related Deals

Directory

Main Forums

Today's Posts

Forum Help

Follow Us