Serial ATA/133 controller


New member
Username: Lickwid


Post Number: 10
Registered: May-04
I have a Serial ATA/133 Controller, its installed and drivers are as well. When i hook my h/d up to it though, when i start up my comp it shows pci listings, normally it would wait like 5 secs tops and then carry on to normal windows startup, with the h/d hooked up it stops at pci listings, dunno why it wont go on. It is set to slave, formatted nothing on it at all. but cannot be recognized. The h/d is ata/100, but the guy at the store told me the 133 card would still work for 100 drives. Any assistance would be appreciated greatly. Thank you in advance.

Silver Member
Username: G3nocd3

San Jose, Ca USA

Post Number: 125
Registered: May-05
Check your bios settings. Booting order etc. Thats how you see if your hard drive is being found. If it shows up not listed it might be a setting in bios, bad drive, not hooking it up right, Jumper setting wrong, cable position wrong (with cable select set in jumpers).Check all these and then let me know what happens.

Unregistered guest
I am having almost thge same problem except when it goes to boot windows it stays on the balck screen, bnut when i hook it up to the motherboard it loads perfectly. It was working fine unitll 3 days ago i returned the card and got a new one but still haveing same problem. It is a belkin ata/133. I am completely baffeld and tried just about everything.
« Previous Thread Next Thread »

Add Your Message Here

Bold text Italics Create a hyperlink Insert a clipart image Add a YouTube Video
Need to Register?
Forgot Password?
Enable HTML code in message

Main Forums

Today's Posts

Forum Help

Follow Us