I downloaded the manual for the x-10 and have everything wired right on the sub for 2 ohms. Ive got the 1000 Alpine monoblock hooked up to it and it jus aint hittin like i know for a damn fact it should. Any thoughts?
so everything is wired right? you have the gain set properly? also that sub will take more power than 1000w. and if you can't give the amp the proper power it needs you aren't even getting the full 1000w out of it.
ignore my post about the rms of the amp. went to alpine to get the real specs and they were different than the site i saw them at. 700wrms @ 12v 1000wrms @ 14.4v those are the specs. still could give more power to the sub.
yea its stock... actually i was gonna ask too... I got a powercap hooked up, but its about the wires. My main power wire is like a 2 Guage Rockford cable. But on my powercap i have a lot skinnier guage wire going from the cap to the amp and the ground from the cap. Do u think id be better off pullin the cap out and runnin the thicker cables straight to the amp?