2 amps wired to 1 sub? HOW?

 

Silver Member
Username: Terps297

Potomac, MD USA

Post Number: 173
Registered: Oct-04
i've got a DD 3500 15" sub and 2 PG Xenon amps that put out 600w @ 1-4ohms.

How do i wire the speaker cable?

(the amps have 2 sets of (+,-) and the manual says the speaker outputs are wired internally in parallel.

How do i wire the RCA's?

Is there anything else i should consider beside matching the gain and sens?

if anyone can draw this out i would reallllly appreciate it.
 

Gold Member
Username: Theelfkeeper

Stockbridge, GA USA

Post Number: 1710
Registered: Feb-05
i replied to your other post in the Amp section i think...
 

Silver Member
Username: Terps297

Potomac, MD USA

Post Number: 175
Registered: Oct-04
yes, thanks again
 

Silver Member
Username: Extrmndor3

Chicago, Ill Us

Post Number: 355
Registered: Feb-06
use y rca splitters and put the two amps with the exact settings and run each amp to each voice coil i have this set up in my explorer but the problem is that im using old p5 sonys amps and i think im pushing like 650 rms and it supposed to push 800 rms combined and is still sounds pretty good im doing 139.8 db at the dash with windows open with this set up , my set up is 18 inch sx with 9.8 cubic ft tuned at 34 hz
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us