Puff

 

Bronze Member
Username: Dj_asya

Montreal, Qubec Canada

Post Number: 58
Registered: May-06
hi is there any file working because i have installed the full emu 201 and is not working u have guys have any link please send or solution thank you and please pardon because i poen a new thread thank specialy nalin could u help me plz tnx bye
 

Gold Member
Username: Justforhahas

Post Number: 1506
Registered: Jul-08
c/p fwank7

V201_Full_EMU works good but has same issues as everyone else and that's when you reboot receiver you get rolling PUFF...

If your receiver is not by the computer, soon as download is complete and you see the first" P " turn the receiver OFF...
Then hook it up and power it on but don't turn it OFF again or it will go to rolling PUFF.

end c/p

So to recap...

Load V201_Full_EMU
Let the box reboot, but power off when you see the first 'P'..
Hook up to TV and power on...do NOT shut OFF
All should be ok!
 

Bronze Member
Username: Dj_asya

Montreal, Qubec Canada

Post Number: 59
Registered: May-06
justforhaha's

still having problem no picture the signal goes up and down could help me plz
 

Gold Member
Username: Justforhahas

Post Number: 1510
Registered: Jul-08
Check your cables and connections again, if losing picture in/out...also switch connection, or some cable or the switch may be going bad..FIRST try a REBOOT, using rear switch off/on..good luck

Signal Strength means nothing except that LNB is connected good to receiver and they are communicating, it can be good even if dish is aimed at the ground..various transponders and channels will change that too ...Signal Quality is very important and different than the strength..
 

Platinum Member
Username: Nydas

Post Number: 13490
Registered: Jun-06
If you can't get out of the PUFFing, try installing an older BIN and then the latest Fwank7 PUFF_201 BIN.


If you are going to use the new PUFF_201 BINs, you will have to accept some limitations. NOTE that this applies to PUFF BINs on 2500/FLU conversions

Rolling PUFF workaround...


c/p fwank7

V201_Full_EMU works good but has same issues as everyone else and that's when you reboot receiver you get rolling PUFF...

If your receiver is not by the computer
, soon as download is complete and you see the first" P " turn the receiver OFF...
Then hook it up and power it on but don't turn it OFF again or it will go to rolling PUFF.

end c/p

So to recap...

Load V201_Full_EMU
Let the box reboot, but power off when you see the first 'P'..
Hook up to TV and power on...
All should be ok!

Then DO NOT SWITCH IT OFF!!
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us