My pansat 3500sd reciever went down last week. in the process of jtaging. I keep getting an load error in the same spot tried with both skybox and wall+jkeys. was wondering my reciever came b80 from factory and the files I have revert back to b70 is there a conflict there if so need to find b80 files future-fta site is closed can any one help!
may not work on some computers.you may need an older version computer or laptop.
1-- i purchased my jtag cable thru ebay 2-- remove cover of sat box only 3 screws. 3-- make sure your sat box is off and your computer is not running any programs. 4-- connect your jtag cable to computer and to reciever. 5-- now turn on sat box on rear switch 6-- open skymax 2.2 can be dowloaded basically any site make sure its a recommended site. 7-- change setting under adr flash to setting 2mb (7FE00000) and make sure select LPT port 1. 8-- under connection click start and wait till complete then under flash operation select erase and wait till complete. 9-- now under flash operation you will select write a window will pop up at the bottom change from rom file to all files. then select the pansat 3500s-flash 1(29LV160CBTC-70)-full.once you selected this file skymax will automatically start the process of writing the file to your sat box.depeding on your computer it may take a while. 10-- once it says complete turn off sat box remove jtag cable. 11-- once jtag cable is removed turn on switch and the display screen should show b70,if so you have completed this procedure correctly. 12-- now you just have to load the boot file 80 and the current bin. 13-- enjoy.
you have to be patience and may have to try this procedures many times.
you telling me. On one the older reciever Loaded the b70 file fine updated to b80 reciever comes on every thing seems fine but no channels only thing I get is bad or scrambled channels screen even on NASA which if true fta. any thing I missed?