|
New member Username: Billytheclub2Brentwood, Ca Usa Post Number: 7 Registered: Oct-05 | just bought an two S12L5 kicker solorberic subs what would be the best way to wire them up? And the subs are dvc 2ohm please help lol. |
|
Silver Member Username: JakeyplaysbassPost Number: 114 Registered: Jul-05 | find an amp that is 1000watts rms at 2ohm and wire them parallel. |
|
New member Username: Billytheclub2Brentwood, Ca Usa Post Number: 8 Registered: Oct-05 | look at the amp is this good enough??? 1200 watt high power 2 channel bridgeable hard kore series car amplifier 1200 x 1 RMS bridged 500 x 2 RMS @ 2 ohms 300 x 2 RMS @ 2 ohms Overload, Short and Thermal Protection Circuit Platinum plated RCA terminals Frequency Response: 20 Hz - 20 kHz Full Mosfet Circuitry Selectable Bass Boost @ 50Hz 2 ohm stable 50dB Channel Separation RCA Line in and out Built in advanced high pass and low pass and flat selectable crossovers 90dB Signal Noise Ratio 22K Ohm Input Impedance Stainless Steel Heatsink Pre-Amp Outputs Built in high powered fan 200mV-2V Input Sensitivity THD <0.05% Selectable Bass Boost (0db - 18dB) 50Hz - 250Hz Low Pass Filter Fuse Rating: 40A x 2 Dimensions: 2.7"H x 12.4"W x 13"L |
|
New member Username: Billytheclub2Brentwood, Ca Usa Post Number: 9 Registered: Oct-05 | phease help me |
|
Bronze Member Username: Baseball1187Columbia, SC Post Number: 25 Registered: Dec-04 | well, that amp is not going to put out anywhere near 1200w. it only has 80a of fusing. you might get 700w RMS. I would suggest you posting your price range and letting somebody recommend an amp for you. There are pretty good amps out there for decent prices. |
|
Bronze Member Username: Baseball1187Columbia, SC Post Number: 26 Registered: Dec-04 | and... if you bought TWO DVC 2ohm subs, wiring all the coils in parallel will result in a .5ohm. you can wire it to .5, 2, or a 8ohm load. The 2ohm would be your best choice. http://www.crutchfieldadvisor.com/learningcenter/car/subwoofers_wiring.html?subs =2&impedance=DVC2x2 |