New to all of this but I am trying to program my Atmega 128 with the JeepersDX by Dave 2 version 2.1.2 and every time I try to Erace I get "Failed to enter proram mode" error.
The config is: Program: Wicked 3m/Bev/Autoroll Network: No RSA ExpressVu Enabler: Wicked-Autoroll Board: 18.432 MHz Time Zone: AST/EDT
Note the the Atmega is differnt from the one I used to have is connects by a 8 pin to the programmer, so it doesn't slide into the programmer, then I have a 25 pin male to male cable connect from the programmer to my printer port.