Pansat 3500 - Only 119 no 110 channels

 

New member
Username: Munndonum

Post Number: 1
Registered: May-06
Alright all you experts out there, here's my problem:
On a pansat 3500S, I am able to see only 119. When I scan for 110 I get essentially the same channels as 119.

My setup was set up by a dish professional for the Dish reciever 301 as follows:
One cable runs from a DishPro Twin LNBF (110 & 119) dish into a DP21 switch (Dish 1) .
Another cable goes from a DishPro Dual LNBF (61.5) into the DP21 switch (Dish 2).
Finally, a cable runs from the DP21 to the Pansat 3500S.

With 119 on DiSEqC 1, 110 on 3 and 61.5 on 2 Here are the results:
A blind scan on 119 gives all the channels for 119, a blind scan on 110 gives the same channels as 119 and 61.5 gives all the channels on 61.5. So my problem is that I am not getting any 110 channels.

By the way, 61.5 only gets channels on DiSEqC 2 & 4. That's why the DiSEqC settings are what I mentioned above.

Also when I hook up the wire from the DP21 to the DN 301, it shows all channels on 110, 119 and 61.5

Anyone able to help?
 

Gold Member
Username: Lklives

Post Number: 2867
Registered: Jan-06
put 61.5 on 4 and 110 on 2...and if that doesn't work then buy another $7 disque switch..

U yourself just said port #3 doesn't work for 61.5...why would the 110 be any different....u have a faulty disque..
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us