Hifonic BXI1606D to 2 SPLW-12's... WILL IT WORK??

 

New member
Username: Coolcat246820

Post Number: 1
Registered: Dec-06
I really need help ASAP. i have been trying to figure this out for months and im still not sure... all i need to know is will this work...

2 SPLW-12's
1 Hifonics BXI1606D

and what would be the MAX wattage i could get to each sub? also best Config? Plz respond as fast as possible.

i have to know within an hour!

Thank you
-Coolcat
 

New member
Username: Coolcat246820

Post Number: 2
Registered: Dec-06
Here are the specs for the subs and amp
Subs-
* 2200 watts power handling
* 1100 watts RMS
* 340 oz. magnet
* 4" BASV/Kapton hybrid 18 AWG voice coil
* FS 33.5(Hz)
* Vas 0.8 cu.ft.
* Qes: 0.34 . Qms: 5.668 . Qts: 0.32
* Xmax: 0.47"
* SPL 90 dB
* Sealed box: N/A
* Ported box: 2.4 cu. ft.
* Tuning: 40 Hz
* Port size: 4" (dia) x 16.75" (length)
* # of ports: 2
* Cloth laminated paper cone with MD6 coating
* Dual 1 ohm voice coil
* Die cast aluminum basket
* Aluminum/chrome dust cap for extra rigidity under extreme conditions
* Black wrinkle finish with Diamond cut
* Chrome finish front & back plate
* Large roll treated foam surround
* One piece, 360º rubber gasket
* Dual conex spider
* Woven tinsel lead through spider
* Chrome binding post terminals
AMP-

* Brutus BXi 1606D
* 1-Channel Mono-Block Operation
* SUPER D-Class Ampllifier Topography
* Ultra-Fi MOSFET Outputs
* Illuminated Hifonics Logo
* PWM MOSFET EXVP (Exponential Vari-Power Supply)
* SPC Twin Turbo-Torroids with Simpatico Coil Design
* Remote Bass Control
* Balanced Line Inputs w/ Optional Hifonics MM-BLD-1
* Gold RCA Line Ouputs - Permit Amplifier Daisy-Chaining
* 4-Gauge Power Connectors

# Fully Adjustable Accu Cross Crossovers Inlude:

* -24dB Subsonic Filter (Adjusts 15-50Hz)
* Phase Shift Adjustments (0 to +180 Degrees)
* 24dB Low-Pass Crossover (Adjusts 35 - 250 Hz)
* Bass Boost: Variable Bass Equalization (+18dB @ 45Hz)


# SPECIFICATIONS:

* 550Wx1 RMS @ 4 ohm
* 1100Wx1 RMS @ 2 ohm
* 1600Wx1 RMS @ 1 ohm
* S/N Ratio: >95dB
* THD & Noise: <0.08
* Input Impedance (Balanced/Un-Balanced): 20k ohm / 47k ohm
 

Gold Member
Username: Juliob

Santo DomingoDominican Re...

Post Number: 3794
Registered: Dec-05
well... if they're dual 4 ohm you should wire them in parallel. In theory the amp will underpower those subs but i don't think SPL is a very good brand. SPL dynamics is another story...
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us