|
Bronze Member Username: TheforgottenmanPost Number: 57 Registered: Aug-06 | A PPI 5440 5 channel. PPI 5440 amplifier A 5 channel amplifier, with four main channels' power output 4У30w at 4 ohm, bridgeable - 2У120w. The 5th "subwoofer" develops 120w at 4ohm, 200w at 2 ohm, and has a separate independent power source. Similar in its main features to PPI 2120. Or Performance Teknique Performance Teknique ICBM-773 SPECS: THD: 0.05% Signal to Noise Ratio: >95dB Frequency Response: 15Hz to 40kHz Crossover: Separates High-pass: 50Hz to 1kHz Variable Low-pass: 30Hz to 500Hz Variable Slope: 24dB Octave Subsonic Filter: 10Hz to 100Hz Variable Bass Boost: 0 dB to 18dB Variable Input Sensitivity: 200mV to 6V Variable Low level Input Impedance: 47K Ohm Damping Factor: 180 into 4 Ohm Channel Separation: >80dB High & Low Level Input through RCA Double Sided PCS Dual Protection (Thermal & Short Circuit) RCA Line Out Power & Diagnostic LED Indicator 2 Ohm Stable Soft Delayed Power On Tri-Mode Capability Power Supply Consumption (Bridged RMS): 35A Fuse Rating: 20Ax2 POWER: 2 Ohms: 150W x 4CH 2 Ohms: 75W x 4CH 4 Ohms: 60W x 4CH Bridged: 150W x 2CH So which one? These will be powering up a MB QUART QSD 216 front and Infinity Kappa 3 ways in the rear. |
|
Gold Member Username: JuliobSanto DomingoDominican Re... Post Number: 2093 Registered: Dec-05 | PPI all the way! |
|
Gold Member Username: TjmutlowPost Number: 2738 Registered: Sep-05 | unless you already have these amps, neither one... i would use the dcx series 600.4 or another brand. |
|
Silver Member Username: NemenPost Number: 979 Registered: Dec-05 | yeah definately ppi |
|
Gold Member Username: Basshead86Google is your Friend, FL Post Number: 4978 Registered: Aug-05 | PPI FTW... |
|
Bronze Member Username: TheforgottenmanPost Number: 59 Registered: Aug-06 | Can someone tell me the specs on the PPI 5440? Like 50x4 4 ohms... something like that. |
|
Bronze Member Username: TheforgottenmanPost Number: 60 Registered: Aug-06 | I have a choices between these two amps because I have both of these already. I am not looking for a new amp until later on. Was planning to get JL 450/4 but I'm tight on budget since school just started. |
|
Gold Member Username: TjmutlowPost Number: 2743 Registered: Sep-05 | i would use the ppi, and if those are the new kappas, you have to run them stereoa(2 0hm load) anfd the others will be ran 4ohm stero mode and |
|
Gold Member Username: JuliobSanto DomingoDominican Re... Post Number: 2100 Registered: Dec-05 | check this www.ampguts.realmofexcursion.com search precision power then look your model |
|
Bronze Member Username: TheforgottenmanPost Number: 61 Registered: Aug-06 | 4 x 30W + 1 x 120W @ 4 ohms 4 x 60W + 1 x 200W @ 2 ohms 3 x 120W @ 4 ohms bridge Fuse: 2 x 30A Manufactured in 1999-2000 Isn't that weaker then the Performance Teknique? |
|
Bronze Member Username: TheforgottenmanPost Number: 62 Registered: Aug-06 | I know PPI, but why the PPI since its weaker then the Performance Teknique? |
|
Gold Member Username: JuliobSanto DomingoDominican Re... Post Number: 2112 Registered: Dec-05 | cuz maybe the performance teknique is overrated... might clip sooner... less quality... pick the PPI |