Wiring question

 

Silver Member
Username: Killswitchjd

Post Number: 278
Registered: Apr-06
so my amplifier is a mono 1200x1 rms amp, but it has two sets of speaker terminals. In the manual it says that the load is internally paralleled. So how do I go about wiring two dual 4 ohm subs to these seperate terminals to get a 1 ohm load?
 

Gold Member
Username: Dustin3

Tigard, OR U.S.

Post Number: 2850
Registered: Oct-05
two dVC sub wire to a 1 or 4 ohm load.

what amp is this? link? and what subs?
 

Gold Member
Username: Tjmutlow

Post Number: 2653
Registered: Sep-05
on each sub run + to + and - to -(voice coil) then run that way to amp(each terminal)
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us