Amp wiring suggestions??????????

 

New member
Username: Tdawg30

Post Number: 1
Registered: Jun-06
I was wondering if I could wire a dual 6ohm sub into 3 ohms and bridge it on a coustic 241SE amp? Can it be done or is there too much stress on the amp?
 

Bronze Member
Username: Bionickusb

Long Island, NY USA

Post Number: 15
Registered: Jun-06
Just about all amps today are capable of running down to 2 ohms so you should be ok... Check the specs if possible
 

New member
Username: Tdawg30

Post Number: 2
Registered: Jun-06
Specs say that it runs at 200watts@4ohms bridged....I just dont want to burn anything up ya know. But thanks!
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us