Amp hookup to stock stereo

 

New member
Username: Turborower

IN

Post Number: 1
Registered: Nov-05
I have a 1990 bmw 735. I want to hookup my Alpine V12 amp to my stock stereo. How do I go about doing this. I have all necessary hardware, i.e. wires, just need guidance. Thanks
 

New member
Username: Ruxpin20

DeTroiT, MIchiGan

Post Number: 6
Registered: Oct-05
Im not a pro at this but, since you dont have rca outputs in your stock radio, you need to get a special connector that will make the speaker wires turn into your rca's, and from there you

wire the rca's to the amp

i dont think you need a remote wire because of that connector you used but if you do wire a remote wire to the amp

wire a power wire back to the amp

then make sure the ground wire is the same size as the power wire and no longer than 2 feed long and bolt that down to the vehicles chasis.

That should be about it....
 

Bronze Member
Username: Crazydude

Post Number: 19
Registered: Nov-05
adam....you might want to look into getting an oem interface. you will get a cleaner signal going in to your amps.
 

Silver Member
Username: Lbeckner

Tulsa, Ok Usa

Post Number: 446
Registered: Oct-04
a line converter

This is what I used off of ebay.

STINGER SALOC HIGH TO LOW LEVEL OUTPUT CONVERTER 35X2.

$20
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us