|
New member Username: Jack137Post Number: 1 Registered: Oct-05 | I have a Volfenhag ZX-8200, 1000 watt 2 channel amp, i dont know the ohm specs...and i have 3 Performance Teknique DVC 10" and there OMH operation is 2,4, or 8 ohm, SO, my question is, how would i go about hooking these 2 subs up to my amp? 2 channels, 3 subs? |
|
New member Username: Jack137Post Number: 4 Registered: Oct-05 | MISTAKE, how would i go about hooking these 2 subs up to my amp? meant 3 subs NOT 2! |
|
Gold Member Username: CarguyPost Number: 4947 Registered: Nov-04 | Bridge the amp into mono then use 2 of the subs. You can't have 3 unless your amp similar to JL. Check your owner's manual. If the amp is 2ohm stable, then configure the subs into 8ohm, then wire them all in parallel. |
|
New member Username: Jack137Post Number: 5 Registered: Oct-05 | yes the amp is 2 ohm stable, how would i configure the subs into 8 ohm? and a prallel how? sorry im new to all the OHM and all that jazz |
|
Gold Member Username: RovinTrinidad & T... Post Number: 1994 Registered: Jul-05 | http://www.the12volt.com/caraudio/woofer_configurations.asp |