Hey, Will this setup work?

 

New member
Username: Genocide

Post Number: 1
Registered: Sep-05
im planning on getting a Pair of Dual XiNC112 12 Inch Subwoofers:

Specs:
* Specifications 12\" brushed metalized silver polypropylene cone
* Inverted style dustcap
* Durable close core foam surround
* \"Mid Q\" design for enclosure compatibility
* Sensitivity: 89dB
* Nominal Impedance: 4 ohms
* RMS power range: 50-175 watts
* Freq. Range: 25-200 Hz
* Cast aluminum basket
* 4 pod blue glow tip 12 volt DC illumination

And a Single amp, im not sure which to get as i don't know much about under-powering or over-powering the subs, im thinking of getting a:
MA Mobile Authority 1000 Watt 4 Channel Amp

Specs:
# Short, Overlaod & Thermal Protection Circuit
# Frequency Response: 20Hz-20kHz
# Full MOSFET Circuitry
# 50dB Channel Separation
# 90dB Signal Noise Ratio
# 22K Ohm Input Impendance
# 200mV-2V Input Sensitivity
# THD <0.05%
# Bridgeable
# Variable High/Low Pass Filter
# High/Low Level Inputs
# RCA Line Outputs
# 0-18dB Bass Boost at 45Hz
# 1000w 4 Channel
# 4x125w @4 Ohm
# 4x250 @ 2 Ohm
# 2x250W @ 4 Ohm

now im wondering if they would go well together, as i can get a pretty good deal if i buy both. Thanks for the input, if they dont match please give me some advice as to what i should get.
 

Silver Member
Username: Tdbdadrummer

Post Number: 127
Registered: Aug-05
Let's put it this way. It will work, but not sound so hot.
 

Silver Member
Username: Rovin

Trinidad & T...

Post Number: 463
Registered: Jul-05
What budget do u have so maybe some1 here can rec a better set-up ?
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us