|
Bronze Member Username: Klone420Post Number: 17 Registered: Dec-04 | How can I run 2 remote wires from the harness of my pioneer DEH-1600 to 2 amps? I've got two amps in the back that are bridged so they only need one wire between them now I want to hook up a third amp (Kenwood KAC-424) to run the tweeters. How can I do this? |
|
Silver Member Username: JeremycKunsan AfbSouth Korea Post Number: 204 Registered: Jun-04 | Just splice into the wire that is all ready back there. No need to run a diffrent wire. I perfer the sodder / shrink tube method. However you could do a simple crimp conector and it should be fine. |
|
Gold Member Username: GlasswolfNorthWest, Michigan USA Post Number: 6069 Registered: Dec-03 | If you're running three or more devices from a single remote trigger line, consider using a relay to boost current for the circuit. This will prevent damage to the head unit. www.the12volt.com has diagrams for wiring relays for this. |